Reading Tags with the ChameleonMini Rev.G

January 06, 2017

These step by step instructions cover how to read an HF Tag (13.56 MHz) with the ChameleonMini Rev.G. 

What you will need:

Take a look at the Getting Started Guide if you need help with the setup process.

1. Connect up your ChameleonMini and start the client.

CMini Rev.G Hookup

2. Inside your client enter the following command to configure the ChameleonMini as a reader. 

Config=ISO14443A_READER

Output:

100:OK=ISO14443A_READER

3. Place tag near the ChameleonMini. Run the read command.

GETUID

Outputs:

Mifare Ultalight

101:OK WITH TEXT
041891EA453181

Mifare 1K

101:OK WITH TEXT
5C9F9F0D

Mifare 4K

101:OK WITH TEXT
FE333A53

Mifare Desfire EV1

101:OK WITH TEXT
04113B624D3C80





Also in Blog

Getting Started with MagSpoof R3 firmware on macOS
Getting Started with MagSpoof R3 firmware on macOS

April 25, 2017

Follow this step by step guide to get started using the MagSpoof R3 firmware on macOS.

View full article →

MagSpoof R3 on GitHub
MagSpoof R3 on GitHub

April 25, 2017

Hardware and software sources for the MagSpoof R3 are now available at https://github.com/RyscCorp/magspoof_r3.

 

 

View full article →

Getting Started with MagSpoof using Arduino IDE
Getting Started with MagSpoof using Arduino IDE

March 27, 2017

This guide covers the process of getting started with the MagSpoof using Arduino IDE.

View full article →