Rysc Corp will be closed for the holidays from December 13 - 27. All orders placed during this time will be shipped on or after December 28.

Rysc Corp will be closed for the holidays from December 13 - 27. All orders placed during this time will be shipped on or after December 28.

MagSpoof R3 on GitHub

April 25, 2017

Hardware and software sources for the MagSpoof R3 are now available at https://github.com/RyscCorp/magspoof_r3.

The hardware changes include:

  • A PCB coil
  • On/Off switch
  • Coin cell battery
  • ISP programming header

The software has been cleaned up and now supports variable swipe speed. Variable swipe speed improves the reliability of reads and can help when working with different readers.






Also in Blog

Getting Started with Version 3.0.1 of the Proxmark3
Getting Started with Version 3.0.1 of the Proxmark3

November 06, 2017

This guide covers how to get started with the Proxmark3 firmware V3.0.1 on Windows, Linux and macOS.

View full article →

Getting Started with ChameleonMini Rev.G
Getting Started with ChameleonMini Rev.G

October 23, 2017

Follow this guide to get started with your new ChameleonMini Rev.G using macOS, Windows and Linux.

View full article →

How to Install a Proxmark3 Driver on Windows 10
How to Install a Proxmark3 Driver on Windows 10

October 18, 2017

Follow the instructions below to install the Proxmark3 CDC drivers on a computer running Windows 10.

View full article →